Auto sample feeding
structure- Computer controlled Auto sample feeding structure enables the
user to put 30 pieces (or more pieces depending on request) of samples.
According to settings of compound information and sequence, the sample
can be automatically send into the die cavity for testing and take it
out automatically from die cavity after finishing test. It can reduce
the work of user would be controlled efficiently, and the testing time
EKT-2003S Moving Die
Rheometer is work of the founder of Ektron Tek who is
also the first computerized Rheometer designer in Asia.
manufactured in accordance with ASTM D5289 & ISO 6502 standards.
The torque sensor is
directly attached to the upper die to avoid friction and mechanical
resistance which influence sensors' precision. The measured torque value
is the real viscosity elastic property of compounds.
This serials of
Rotorless Rheometer adopt new designed die structure provides simple
test piece loading and removing, and ensures the vulcanization
properties of rubber compounds are presented perfectly due to the fact
that test specimens in the die cavity are held firmly.
device installed on the upper die eliminates extra resistance forces
generated from the oscillating structures and can enhance its
During test, the
computer can automatically measure some viscoelastic curves such as:
Elastic torque curve, Viscous torque curve, Viscous-Elastic torque
curve, Tancurve, Loss angle curve, Curing rate curve, Upper/lower die
temperature curve. (Note: 2000SP model can get some more curves of foam
pressure and pressure rate)
Multiple control gates
are available for controlling the specified data such as ML, MH, TS, and
TC. And extra 18 control points are also supplied for the user to set
some control gates at any time point of a cure curve.
Standard accessory - SPC
(Statistical Process Control) software of moving die rheometer is used
to analyze and draw the statistical control charts including X-RM, -R,
histogram, and normal distribution for some specified data.